Thread: Reaming dies?
View Single Post
Old January 3, 2013, 11:50 AM   #2
Magnum Wheel Man
Senior Member
Join Date: July 26, 2006
Location: Southern Minnesota
Posts: 9,333
I have a retired tool & die guy that I believe has done this several times, but I don't know any of the specifics... ( I'm sure some brands are harder steel than others, obviously hardened components carbide, nitride, etc. would create problems )
In life you either make dust or eat dust...
Magnum Wheel Man is offline  
Page generated in 0.03240 seconds with 7 queries