View Single Post
Old January 1, 2013, 06:45 AM   #3
Doc Hoy
Senior Member
Join Date: October 24, 2008
Location: Chesapeake, VA
Posts: 5,105

I am with Sourdough on his comments.

I don't use the bottom spout for anything but making ingots.

Also agree with his comments on high and low temps and their impact on the quality of the bullet.

I have the same pot and have used it for about 30 years. I cast at about 7 on the dial. I do find that some mold seem to like different temperature settings.

I only have a little experience with the new Lee mold design but it seems to want to cool down quicker and so I raise the setting of the furnace just a bit. That observation is very preliminary and I may find that I am completely wrong after more experience.

My reading of history convinces me that most bad government results from too much government. Thomas Jefferson
Doc Hoy is offline  
Page generated in 0.03374 seconds with 7 queries