View Single Post
Old December 13, 2012, 12:17 PM   #30
Senior Member
Join Date: February 7, 2009
Location: Southern Oregon!
Posts: 2,326
Wouldn't modifying dippers lead to measurement errors?
Nope. The internal capacity of the dipper remains the same, doesn't change while using. Whether the factory or I determine the capacity of a dipper it will always be the same. I determine the capacity to dip a specific charge (having done this for quite a while, I've developed a method that is very consistent, and usually check repeatedly with a scale).
My Anchor is holding fast!
I've learned how to stand on my own two knees...

Last edited by Unclenick; December 15, 2012 at 04:49 PM. Reason: setting quotation off for easier reading
mikld is offline  
Page generated in 0.03945 seconds with 7 queries