View Single Post
Old November 27, 2012, 04:43 PM   #94
Aguila Blanca
Senior Member
Join Date: September 25, 2008
Location: CONUS
Posts: 9,684
How does it look internally? These are the "extra" parts:

The upper plunger and spring are in the slide. The two levers are in the frame. The right side of the frame has to be milled out (beside the hammer and sear) to make room for the levers. In the slide, the firing pin has to have a "waist" in the rear section to interface with the plunger.
Attached Images
File Type: jpg series80safety.jpg (11.3 KB, 3 views)

Last edited by Aguila Blanca; July 24, 2017 at 11:45 AM.
Aguila Blanca is offline  
Page generated in 0.03773 seconds with 8 queries