View Single Post
Old November 26, 2012, 08:00 AM   #50
Senior Member
Join Date: March 1, 2009
Posts: 1,018
have you tried chambering a case that has been sized but no powder or bullet seated yet like I suggested a few posts back. That would narrow it down to either seating depth or improper case sizeing

you need to find out which component is giving you the issue, until then you are just chasing your tail.

Anyway unless you have some bodacious neck tension going on there the bullet depth is not going to stop you from closing the bolt. It is a fairly common practice for BR shooters to seat the bullets into the lands depending on the barrel
“Only accurate rifles are interesting,” - Col. Townsend Whelen

Government is like a baby. An alimentary canal with a big appetite at one end and no sense of responsibility at the other. - Ronald Reagan

Last edited by hounddawg; November 26, 2012 at 08:26 AM.
hounddawg is offline  
Page generated in 0.04589 seconds with 7 queries