View Single Post
Old November 25, 2012, 02:08 PM   #27
Junior member
Join Date: July 13, 2012
Posts: 179
I just tooo apart the rifle to stop any questions to the integrity of the bolt. Everything is exactly the same, the new problem is i gotta reassemble the rifle to work properly again, which is a whold new problem in itself.

Anyways, I have the same exact problem with the rifle apart from the stock as i did with it together. The rounds just wont allow the bolt to close fully!

My press has the die screwed all the way down to the shell plate.. I cannot push the "shoulder", as recommended, any further back... so therefore, the damn bolt just wont close. What else do I do or am I screwed and forced to not shoot .308 anymore?

DASHZNT is offline  
Page generated in 0.04071 seconds with 7 queries