View Single Post
Old November 25, 2012, 01:38 PM   #26
Senior Member
Join Date: March 1, 2009
Posts: 1,016
I had this issue occur in the field a while back when I changed the trigger guard to a 10rd magazine, the bolt would be almost completely closed but it wasnt, I unscrewed the trigger guard and screwed it back in slowly tightening down until everything worked fine and closed fully and the rifle worked
from your original post. I guess I am confused here. Does loosening the trigger guard screw clear up the problem or is this a different problem?

Now if this is something different will a unloaded case chamber correctly after resizing with no bullet seated. That would narrow it down to a COL or case resize issue and you can go from there with it
“Only accurate rifles are interesting,” - Col. Townsend Whelen

Government is like a baby. An alimentary canal with a big appetite at one end and no sense of responsibility at the other. - Ronald Reagan

Last edited by hounddawg; November 25, 2012 at 01:43 PM.
hounddawg is offline  
Page generated in 0.15072 seconds with 7 queries