View Single Post
Old November 25, 2012, 01:32 PM   #18
Senior Member
Join Date: July 15, 2006
Location: Fern Creek ,KY and Metro Louisville at large
Posts: 425

Note to self:

Don't let these guys work on your gun
I assume you where referring to me

I said as long as the muzzle was square and concerntric

Square and concentric

A lathe is best
Piloted tooling is secondary

A drill would work to crown a muzzle as long as it was square and
Especially for a counterbore.

And my answer was to the OP
CW Shooters Supply Inc
Machine Shop and Finishing Services to the trade and public
guncrank is offline  
Page generated in 0.03258 seconds with 7 queries