View Single Post
Old November 25, 2012, 09:48 AM   #22
Senior Member
Join Date: January 15, 2012
Location: Western New York
Posts: 462
I had a similar problem once, bolt wasnt closing. try taking your finished round and drop it in your case gage. If you checking your brass with the case gage before you seat a round and it fits fine is good, but you should always check after you seat a bullet. My problem was I was bulging out the shoulder from too much crimp.
Lock and load, the zombies (democrats) are coming (to take your guns)!
mohr308 is offline  
Page generated in 0.03073 seconds with 7 queries