View Single Post
Old November 23, 2012, 08:57 AM   #3
Senior Member
Join Date: April 16, 2009
Location: Fort Worth, Texas
Posts: 194
There is a slight bevel, usually caused by aggressive tightening of the mag extension causing the edge to roll inward, it can happen in the factory.

Cheapest solution, use a round file and remove the bevel

Best solution: remove bevel with round file and order a Choate Hi-Viz follower

No amount of lube will solve the issue
NRA Life Member
Orphanedcowboy is offline  
Page generated in 0.03716 seconds with 7 queries