View Single Post
Old November 18, 2012, 08:44 PM   #14
Senior Member
Join Date: November 30, 2010
Posts: 3,464
Well I found a solution, after hand chambering a round as I follow the slide home if I depress the back of the extractor so it springs out there is no contact with the case rim as it goes over it. Hassle? Yes but I would rather not have to throw out ammunition that costs about a buck a round after chambering it a couple times.

Last edited by Dragline45; November 18, 2012 at 09:04 PM.
Dragline45 is offline  
Page generated in 0.03120 seconds with 7 queries