View Single Post
Old November 18, 2012, 06:02 PM   #7
Senior Member
Join Date: October 4, 2011
Location: Australia
Posts: 317
I can't imagine more force is necessary, i've putting pushing down the ram very hard and have cracked the table i was using necessitating a remounting of the press onto a special bracket so it can't be that.

I've set up the die according to the instructions. I might look into this undersized mandrel option. Thanks guys

if i take sandpaper to it, how much will i need to take off?
davery25 is offline  
Page generated in 0.03046 seconds with 7 queries