View Single Post
Old November 17, 2012, 05:47 PM   #48
Senior Member
Join Date: August 1, 2010
Location: Tampa Bay
Posts: 4,370
I inspect my brass/cartridge at every step of the process. Progressive presses deny that opportunity.

The cases in the LNL are retained in the shellplate by simple spring. I can remove any case, from any station, at any time- by simply pulling it out.

And I often do. I constantly spot check charge weight, bullet seating depths to be sure nothing's gone "off"...

If a primer seating didn't feel "right"... I take it out, and look at it...

The LNL can be EASILY run one case at a time, just like a single stage press.
tobnpr is offline  
Page generated in 0.03819 seconds with 7 queries