View Single Post
Old November 13, 2012, 01:55 AM   #25
Senior Member
Join Date: August 25, 2008
Location: 1B ID
Posts: 10,200
Tonight, I found myself getting bored and moderately fatigued while loading some .44 Mag, after prepping a bunch of brass.

My solution: I poured the powder back in its container, wrote down what I was doing and that the next charge increment was due (load data was already recorded), covered the press and scale, and walked away for the night.

There are quite a few brass prep, sizing, or expanding tasks I'll perform while tired/fatigued (if needed), but I don't mess with powder. If I have to call it quits, I come to a good stopping point and walk away. I don't try putting things away and moving to a less critical task. I just take care of any open powder or primers, and leave everything right where it's at.
"Such is the strange way that man works -- first he virtually destroys a species and then does everything in his power to restore it."
FrankenMauser is offline  
Page generated in 0.04896 seconds with 7 queries