View Single Post
Old November 6, 2012, 07:43 PM   #10
Senior Member
Join Date: February 16, 2006
Location: IOWA
Posts: 7,016
At face value, I think it's a good idea. However ,

I am not comfortable with the possibility of having to decock a revolver that does not have a hammer spur, and the idea of bobbing it anyway is that you will primary/solely fire the gun DA anyway, so why not make it DAO for a little more safety margin?
Chaim, brings up a valid point and possible safety issue. What's going to happen when you trade or sell the gun? ..

Probably not a good idea. The hammer needs a certain amount of mass to generate enough force to dent the primer. No mass = no detonation.
These 85's usually come with internal spring that are too strong so this should not be an issue.

Be Safe !!!
'Fundamental truths' are easy to recognize because they are verified daily through simple observation and thus, require no testing.
Pahoo is offline  
Page generated in 0.04023 seconds with 7 queries