Thread: Will it fit?
View Single Post
Old October 18, 2012, 03:41 PM   #4
Senior Member
Join Date: September 9, 2008
Location: Woooooshington
Posts: 1,797
See this chart... and know that Burris measures rings from the ring base to the bottom of the scope tube rather than the centerline.

So... say your objective bell measures 2.125"... using the chart, you need at least .563" from your receiver to the bottom of the scope 1" tube. Even if you include the height of the bases (about .250"), it still comes in under 1"... so the "Burris Xtreme Tactical 1 Inch Riflescope Ring Pair, Extra High 1in" is, in a word, excessive.

Shoulder Drive Nicholson Club
Creeper is offline  
Page generated in 0.05086 seconds with 7 queries