View Single Post
Old October 14, 2012, 09:15 AM   #1
David Bachelder
Senior Member
Join Date: August 23, 2011
Location: Trinity, Texas
Posts: 633
Gunsmith, near Huntsville Texas?

I have never taken a gun to a gunsmith except many years ago to have a recoil pad put on. Many, many years ago. I have a question.

I need the barrel on a Ruger BlackHawk (45 Colt) cut off. It's 7.5" long now and I want it cut off to 6.5". Where would a good gunsmith be found close to Huntsville Texas? About what would a job like that cost? Would it be more cost effective to replace the existing barrel with a shorter one?
David Bachelder
Trinity, Texas
I load, 9mm Luger, 38 and 40 S&W, 38 Special, 357Magnum, 45ACP, 45 Colt, 223, 300 AAC, 243 and 30-06
David Bachelder is offline  
Page generated in 0.03332 seconds with 7 queries