View Single Post
Old October 13, 2012, 09:57 PM   #38
the led farmer
Senior Member
Join Date: July 8, 2012
Location: so cal
Posts: 246
Here is my question, if I'm using the bullet seating die correctly and achieving the correct OAL, there is NO need to crimp at that station if my next station is the Factory Crimp Die...right

IF you are using the bullet seating die to seat the bullet ONLY and NOT to crimp then you are correct, you DO NOT want to crimp here. If you are not clear on how to do this pm me. Also i assume you are using lee dies i am not sure you specified)
the led farmer is offline  
Page generated in 0.05572 seconds with 7 queries