View Single Post
Old October 6, 2012, 09:19 AM   #5
Senior Member
Join Date: February 21, 2011
Location: way out here
Posts: 151
.40 bulges

Magma Engineering, of Queen Creek, Az., makes a Sizemaster Jr., for taking bulged cases back to factory specs. It runs the fired brass base first through a carbide die; I hook a Dillon case feeder to it, and can do about a thousand an hour.

At $325, its not the bargain unit, but it sure does work great. To be safe, I do not use these brass for top end loads, but have many, many mid range loadings on them before they split like any other brass.
zplinker is offline  
Page generated in 0.04311 seconds with 7 queries