View Single Post
Old October 1, 2012, 07:32 AM   #17
Metal god
Senior Member
Join Date: April 10, 2012
Location: San Diego CA
Posts: 3,802
Pmags are known to have issues with certain lowers. Tight fit in the mag well and not dropping free is the most common.
+ 1 on that . I have a PSA lower that has problems with some pmags ( tight fit ) Cus there plasic , I was able to shave the areas down a bit that were rubbing , They work fine now
Tolerate- allow the existence, occurrence, or practice of something that one does not necessarily like or agree with , without interference.
If you have some time IMO this is worth a listen/watch but it takes a few minutes to really get going . or a picture of Mohamed
Metal god is offline  
Page generated in 0.03368 seconds with 7 queries