Thread: Arbor Ding?
View Single Post
Old September 15, 2012, 07:29 PM   #6
Ideal Tool
Junior member
Join Date: October 6, 2010
Location: Michigan
Posts: 1,080
Hello, red96ta..are you absolutly certain it wasn't on there when you purchased the gun? That arbor has's surface is glass hard..but only a few .001"'s of an inch deep. A ding would have pushed metal surface in..but color wouldn't have changed..that mark almost looks like a file cut..the metal is bright..can't imagine a properly fitted cyl. being able to cock that much. Many times over the years, after I have had a brand new gun..or even a used one..I will find little marks or dings I never noticed before.."How'd that get there"? Could this be the case?
Ideal Tool is offline  
Page generated in 0.04106 seconds with 7 queries