View Single Post
Old August 31, 2012, 04:18 AM   #59
Senior Member
Join Date: August 25, 2008
Location: 1B ID
Posts: 10,513
As I've stated, I have not had the need for the Lee FCD. I'm not saying that it isn't helpful for others either. My concern would the post sizing of cast lead rounds. Bullet fit is critical if you want to keep leading to a minimum. I would think that post sizing may lead to increased leading. Has anyone had any issues in regard to this?
This is one of those things on the net that I have seen written with a "could" or "might" many many times, but have never actualy seen a firsthand report of a problem....


.356" lead bullets
After going through a Lee Carbide FCD, the bullets come out at .355" and lead like crazy.

At .356" everything is fine.
After a trip the the FCD and getting sized down to .355" on the bearing surface... it all goes to crap.
"Such is the strange way that man works -- first he virtually destroys a species and then does everything in his power to restore it."
FrankenMauser is offline  
Page generated in 0.04959 seconds with 7 queries