View Single Post
Old August 26, 2012, 10:34 AM   #11
Doc Hoy
Senior Member
Join Date: October 24, 2008
Location: Chesapeake, VA
Posts: 5,105
More photos

Here, the dullet is seated with the grooves all the way into the small diameter.

Then the bullet in the block is positioned over the shell and the tee handle pushes the bullet into the case just far enough toget it started.

From here the bullet goes into the press for final seating and crimping.

Perhaps when I get better at this, I won't need this device to get the bullet started straight.

My reading of history convinces me that most bad government results from too much government. Thomas Jefferson
Doc Hoy is offline  
Page generated in 0.03364 seconds with 7 queries