View Single Post
Old August 20, 2012, 04:32 PM   #8
Senior Member
Join Date: October 28, 2006
Location: South Central Michigan...near Ohio, Indiana.
Posts: 5,040
I have a couple of Lee Factory Crimp Dies for pistols that I want that to happen to. The carbide ring at the bottom sizes the loaded cartridge in the last station of my 550b and crimps it. I do not like the carbide ring working the bullet and the case, would prefer that the did just crimp. Tempted to try and knock the ring loose...but they are likely brazed in. Now if the OP would just teach me how to do it to a Lee...
dahermit is offline  
Page generated in 0.03561 seconds with 7 queries