Thread: Sight question
View Single Post
Old August 7, 2012, 11:16 PM   #4
Senior Member
Join Date: September 9, 2008
Location: Woooooshington
Posts: 1,797
Ah... gotcha.

Yeah, I guess you can Loc-tite it, but you'd be better off carefully applying a center punch on the edges of the sight dovetails, on the bottom surface.
This will displace metal to the edges in a controllable fashion, effectively widening and raising the sight as necessary, and causing it to fit tighter in the slide... and still allow adjustability.

Shoulder Drive Nicholson Club
Creeper is offline  
Page generated in 0.05076 seconds with 7 queries