View Single Post
Old August 4, 2012, 08:03 PM   #15
Senior Member
Join Date: December 31, 2011
Location: Vermont
Posts: 1,967

INITIALLY the ejector rod worked fine in all 6 chambers, after some shooting it works in 2 of the 6..............

Not according to your original post on this issue before it went back to Ruger it didn't:

The store owner was showing me how to load/unload the rounds. When we were turning the cylinder the ejector rod would go into some chambers correctly,

Which is it?


As I said in the original thread, I firmly believe this is an example of you (and your FFL) not being familiar with Ruger 'New Model' Blackhawk operation...
Salmoneye is offline  
Page generated in 0.03690 seconds with 7 queries