View Single Post
Old July 9, 2012, 10:23 PM   #29
Senior Member
Join Date: December 20, 2007
Location: S.E. Minnesota
Posts: 4,295
I'm new at this (rifle reloading) but I wanna take a guess. Looks like a crimp die set too tight.

Did you trim the cases? If 4 of them were a little long, the seating die would start to crimp early, even if you didn't intend for it to crimp.
"The only way to stop a bad guy with a gun is with a good guy with a gun"
zxcvbob is offline  
Page generated in 0.05579 seconds with 7 queries