View Single Post
Old May 29, 2012, 01:02 PM   #10
Senior Member
Join Date: August 4, 2005
Posts: 2,017
Also. they have eliminated a lot of lead bullet loads and IMHO have just been pushing ATK affiliate, Speer, jacketed bullets. When I last check there was no lead bullet data for 9MM, .40 S&W, or 10MM.
Funny thing about lead--it's not difficult to load for even without published data for it. First, find a comparable bullet listed by weight and similar profile, then look at the pressures associated to the load data. If the pressures are within your lead alloy limit by BHN, you're good to go. Pressures with lead will be less than the jacketed load anyway, just start at the bottom and work your way up as usual.
"Why is is called Common Sense when it seems so few actually possess it?"

Guns only have two enemies: Rust and Politicians.
Rangefinder is offline  
Page generated in 0.03699 seconds with 7 queries