View Single Post
Old May 21, 2012, 10:23 PM   #2
Senior Member
Join Date: May 25, 1999
Location: Too close to Houston
Posts: 4,196
It's in far enough if it presses the primers out. You don't want it up too high because there's not enough room for the neck between the neck sizing button and the neck sizing part of the die.

A little above flush is fine on my Lee dies.
Proud member of the NRA and Texas State Rifle Association. Registered and active voter.
Sport45 is offline  
Page generated in 0.03539 seconds with 7 queries