View Single Post
Old May 13, 2012, 01:02 PM   #4
Senior Member
Join Date: December 20, 2007
Location: S.E. Minnesota
Posts: 4,295
I do. It works just fine. I paint the case heads with a Magic Marker or fingernail polish to make them easier to find -- I hate leaving one behind.

It's been a while since I trimmed a batch of them; I *think* it works best if you decap them with a universal decapper or a pin punch (I just use a .45 Colt die) then expand the necks with a 9x18 expander, and then trim them. Then you can resize them with a 9x18 sizer die.

It's a lot of work, but it goes pretty fast once you get going. Not worth it if you lose most of them in the grass.
"The only way to stop a bad guy with a gun is with a good guy with a gun"

Last edited by zxcvbob; May 13, 2012 at 01:07 PM.
zxcvbob is offline  
Page generated in 0.07307 seconds with 7 queries