View Single Post
Old May 7, 2012, 11:36 PM   #3
Senior Member
Join Date: July 21, 2011
Location: Idaho
Posts: 7,729
ok a little update. after comparing the remington 1903A3 to my springfield 1903 I now notice a lot that's missing from this rifle. I ordered just about everything but the bayonet lug and rear sight from numrich. also I have determined that the bolt is an A4 style bent bolt to accommodate a scope my main concern with this is that it does not fully rotate like it's supposed to, will this cause problems or will it be fine? shaving off a little bit of the stock would alleviate the problem but I would rather not mess with it if it isn't a big deal.
ignore my complete lack of capitalization. I still have no problem correcting your grammar.
I never said half the stuff people said I did-Albert Einstein
You can't believe everything you read on the internet-Benjamin Franklin
tahunua001 is offline  
Page generated in 0.05468 seconds with 7 queries