View Single Post
Old April 29, 2012, 11:45 AM   #11
Junior member
Join Date: August 8, 2009
Posts: 374
Heck...The only flaws I can find on the whole dang piece is a VERY faint line of bolt drag on the cylinder and the bolt notches in the cylinder have a very small gouge on both sides
There is your answer. The bolt is not fitting the bolt slots in the cylinder. Measure the bolt width and all the slots, and adjust thebolt width accordingly.
zullo74 is offline  
Page generated in 0.04676 seconds with 7 queries