View Single Post
Old April 20, 2012, 03:13 PM   #22
Senior Member
Join Date: June 16, 2008
Location: Wyoming
Posts: 10,835
I take a factory load and use it to set the crimp on the Lee Factory Crimp die.

Then when I get the bullet seated flush. I but the round in the Crimp die, which leaves the same crimp as you have on the factory bullet.

That only works with Nagant 7.62X38R brass. I just seat the bullet on 32-20 brass where it fits the cylinder.
Kraig Stuart
USAMU Sniper School Oct '78
Distinguished Rifle Badge 1071
kraigwy is offline  
Page generated in 0.03655 seconds with 7 queries