View Single Post
Old January 31, 2012, 11:34 AM   #5
Senior Member
Join Date: November 16, 2010
Location: Arkansas
Posts: 996
Yep, the separate display on the bench is much better as you can control it without moving from the bench. A few ideas are to use soda straws instead of the steel rods so that if you hit one it won't break the plastic sensor housing and put tape at 4" and 6" above the sensors as this is the ideal area you want the bullet to pass over the sensors.

How do them straws hold out with a light wind. Seems that my outdoor range always has a light breeze, unless it's the dead of summer and you need one.
NRA life member

When the going gets tough, I just open another beer.
bossman is offline  
Page generated in 0.03262 seconds with 7 queries