View Single Post
Old January 21, 2012, 09:19 PM   #2
Senior Member
Join Date: July 26, 2011
Location: USA
Posts: 1,612
Brass needs to be trimmed to the same length. A bulge is from having the die turned down to far. (standard dies) To keep the bullet from moving, try to increase neck tension by making the expander .002" or more smaller than bullet diameter. The Lee Factory Crimp die is used by some reloaders. But good neck tension is much better than a crimp.
243winxb is offline  
Page generated in 0.08688 seconds with 7 queries