View Single Post
Old December 30, 2011, 10:50 PM   #1
[email protected]
Senior Member
Join Date: August 21, 2008
Location: Kansas City
Posts: 1,393
Loading A Tight Ball In A Rifle

As some of you know, I like a very tight fitting ball in my rifles. Some of you
have wondered just how I could load such a tight combo. Well I found a old
video I made over 20 years ago. Here I am loading a .454 dia ball with .020
thick patching in a measured .450 bore rifle. I use a 1/4 inch dia steel loading
rod. Notice how easy it goes down. My wife loads a .410 dia ball in her .400
bore Green Mountain barrel and it loads just as easy. This with .020 patching
also. Just watch is offline  
Page generated in 0.04221 seconds with 7 queries