View Single Post
Old September 7, 2011, 01:37 PM   #2
Senior Member
Join Date: December 23, 2008
Location: Southern Illinois
Posts: 1,525
The reloading process is the same. Some guys use faster burning powders and some guys use slower burning powders with reduced charges. Be aware of powders that are position sensitive in the case...especially if reloading large case volume cartridges.

I use H4895 for most all of my cast rifle loads (7.62x54r, 7.5 swiss)

You will probably want to invest in a Lee universal flaring die and put a SLIGHT bell on your rifle case necks so you don't shave lead OR swage the bullet down when seating in the case. I then use the crimp in the seating die to just remove the slight flare.

Good luck!

IllinoisCoyoteHunter is offline  
Page generated in 0.03294 seconds with 7 queries