View Single Post
Old August 8, 2011, 10:00 PM   #3
Senior Member
Join Date: January 1, 2011
Location: West Central Florida
Posts: 463
If you are comfortable with doing it....

While in a safe area and keeping the muzzle pointed in a safe direction gently remove the takedown knob located on the end of the lower tube. Then very carefully remove the barrel from the receiver. It should easily slide out and off of the loaded round, which can then be removed from the extractor. If you encounter any resistance with the barrel, STOP. And, see below...If, not, then remove the remaining rounds and then drive the pin out that holds the trigger group in. Then you can assess your problem.

Or...just take it to a competent gunsmith. Call ahead and request advice on proper etiquette or leave it in the vehicle until you explain your situation to him/her.

Good luck and let us know what you find...
BILL @ Strongside Arms, Inc. - 1479 W. C-48 Bushnell, FL 33513 352-568-0017
“Why worry when you can pray? He [God] is the Whole, you are a part. Coordinate your abilities with the Whole.” ~Edgar Cayce~
GoOfY-FoOt is offline  
Page generated in 0.03899 seconds with 7 queries