Thread: suppressors
View Single Post
Old January 20, 2011, 05:50 AM   #4
David Hineline
Senior Member
Join Date: December 23, 1999
Location: South Sioux City, Nebraska
Posts: 704
9/16X24 works fine in a mount, you would need about .600 of exposed threads and a square shoulder and check that the threads on the end of the barrel are aligned with the bore, the accuracy needed in threading to get the bullet out of a 2" compensator and out of an 8" silencer with a tight bore hole are two different types of threading.

Ask over on and someone has probably done it.
David Hineline is offline  
Page generated in 0.03033 seconds with 7 queries