Thread: lee 4 20 pot
View Single Post
Old January 13, 2011, 08:20 AM   #3
Senior Member
Join Date: April 6, 2009
Location: SWPA
Posts: 428
There are better bottom pour pots on the market, but for the money you can’t beat the Lee.
Two big mistakes guys make with them. Make sure you keep all the junk out, only put clean ingots in the pot, and also don’t use the commercial Fluxes; they will rust the pot and add junk that will cause them to drip, more than usual.
Lees all drip to some extent, a fix I did on my 4-20 was to snap a 45ACP case on the top of the flow rod, with the primer out. The primer pocket will snap on to the top of the rod, and then fill the case with Lead, and this weighs it down enough. The dripping stopped
hornady is offline  
Page generated in 0.03253 seconds with 7 queries