The Firing Line Forums - View Single Post

azphx55 · December 6, 2010, 12:30 AM

I've tried everything I can think of, but it just doesn't feed reliably, by which I mean that MOST of the time it drops 0.0 grains when set to 4.8 or bigger.

This is on a Lee Classic Turret with Pro-Disk. I'm using just the charge bar alone, not doubled up with a disk.

I've tried Trail Boss, Titegroup and Win231. I've run graphite through the system and I've tried tapping the assembly constantly.

If I remove the charge bar and put a disk in its place, I get perfect feeds.

I'm having trouble understanding how a hole in a piece of plastic can be defective to the point that things won't fall through it, and am just about at the point where I throw it in the trash and write a whiny post about it.

December 6, 2010, 12:30 AM	#1
azphx55 Member Join Date: September 7, 2010 Posts: 85	Lee Adjustable Charge Bar I've tried everything I can think of, but it just doesn't feed reliably, by which I mean that MOST of the time it drops 0.0 grains when set to 4.8 or bigger. This is on a Lee Classic Turret with Pro-Disk. I'm using just the charge bar alone, not doubled up with a disk. I've tried Trail Boss, Titegroup and Win231. I've run graphite through the system and I've tried tapping the assembly constantly. If I remove the charge bar and put a disk in its place, I get perfect feeds. I'm having trouble understanding how a hole in a piece of plastic can be defective to the point that things won't fall through it, and am just about at the point where I throw it in the trash and write a whiny post about it.