View Single Post
Old November 23, 2010, 09:16 PM   #9
Senior Member
Join Date: May 20, 2001
Location: Oshkosh wi.
Posts: 3,051
I'll post a report when I try it......the mold will have no sprue plate, plan on cutting the sprue off with a band saw.
This is not to take the place of lead bullets.....or any other purpose than just "because", I just want to see how it will work out.
It won't work. Brass will shrink too much, you'll have way undersized bullets. I also doubt it will flow well enough to fill out lube grooves.

Band saw? I fail to see how you could possibly cut the base square and smooth enough to get a usable bullet.

But it sounds like you're determined to do this, so have fun.
The more people I meet, the more I love my dog

They're going to get their butts kicked over there this election. How come people can't spell and use words correctly?
snuffy is offline  
Page generated in 0.10237 seconds with 7 queries