View Single Post
Old October 27, 2010, 04:57 PM   #18
flashhole
Senior Member
 
Join Date: February 9, 2005
Location: Owego, NY
Posts: 1,844
In the setup I'm showing there is no FL sizing die. I do my sizing on a single stage press. You may consider both a single stage and a turret as you can get both the Classic Cast single stage and the Classic Turret for a lot less money than you will pay for a Redding T-7. You will get a lot of use out of both types of presses.

To your point ... I don't know if the relief on the back side of the turret support on the Redding T-7 will allow clearance of the funnel as shown in my photo.

I'm a big Redding fan by the way. Here is a shot of my bench. You can see I'm also a big fan of Lee equipment.

__________________
,,, stupidity comes to some people very easily. 8/22/2017 Pat Lengyel (my wife) in a discussion about Liberals.
flashhole is offline  
 
Page generated in 0.03698 seconds with 7 queries