Thread: got sig?
View Single Post
Old October 27, 2010, 04:44 PM   #23
Uncle Malice
Senior Member
Join Date: May 11, 2009
Location: Phoenix
Posts: 4,460
I dropped my P6 off at Robar this morning for a complete NP3 treatment on slide/frame/internals. I asked what the turn around we are looking at currently and was told 6 weeks, which is quite a bit less than the usually reported 8-12 weeks. I assume that there is not as big of a back log at the moment, so it may be a good time to send in your guns if you've been thinking about getting NP3 done!

I was waiting until I got all of my 'upgrade' parts delivered and installed for the P6 before I dropped it off. I finally got everything finished up yesterday afternoon. The upgrades that I did to it include the solid style hammer, short trigger from customized creationz, standard P225 weight mainspring, and P225 'parts kit' - which includes recoil spring, decocker spring, trigger spring, locking block spring, grip screws, etc... The gun feels really nice with the lighter spring and short trigger.

I also ordered these grips after I dropped the gun off at Robar. I can't wait to get it back and see how she runs!

With the cost of the gun, the grips, parts, and Robar, I'm now going to have a little over $800 into the gun... which is probably a little absurd for a P6, but that's okay. I'm not doing it for 'resale value'. I'm doing it so the gun is mine...
M&P M2.0 Compact | Glock 43 | Glock 26 G4 | Glock 19 G4 BFG | HK USP 9 | HK USP 45 (Tan) | HK P2000 | HK P30L | HK VP9 | HK 45 C | HK 45 C "Sand" | Walther PPQ 9
Daniel Defense DDM4 V4 | Arsenal SGL 21 | ASA Side-Charger SBR | Savage Mark II FV-SR
Mossberg 590A1 20" SP | Mossberg 590A1 14" Shockwave
Uncle Malice is offline  
Page generated in 0.06693 seconds with 7 queries