View Single Post
Old August 12, 2010, 09:56 PM   #2
James K
Join Date: March 17, 1999
Posts: 24,160
There is no reason the trigger pull of an N frame S&W in .45 Colt would be any heavier than one in .357 or .44. Unless something is wrong with that gun, the trigger pull can be smoothed and lightened the same as any other S&W.

Since the hammer on an N frame is large and heavy, the spring weight can be reduced some without danger of misfires but, as with any such work, the revolver should be fired at least a couple of hundred rounds to make sure there is no problem.

May I suggest, though, that you might not have the experience to do the work yourself and might want to consult a gunsmith.

Jim K
James K is offline  
Page generated in 0.05274 seconds with 7 queries