The Firing Line Forums - View Single Post

Sevens · July 5, 2010, 10:54 PM

I can't add any help to this thread but I did want to add a little love from my corner of the bench. These dies allow you to not only resize your rifle brass without using lube, without the hassle and work of FL sizing, but they also stress the brass quite a bit less than full length sizing does.

I love 'em and would rather buy them in deluxe sets with the other dies than have to buy them by themselves later. (they cost more that way)

For all the folks that burn energy campaigning against "cheap" Lee products, I can't imagine many folks who have bought and used Collet neck-only size dies and didn't end up loving them.

July 5, 2010, 10:54 PM	#12
Sevens Senior Member Join Date: July 28, 2007 Location: Ohio Posts: 11,775	I can't add any help to this thread but I did want to add a little love from my corner of the bench. These dies allow you to not only resize your rifle brass without using lube, without the hassle and work of FL sizing, but they also stress the brass quite a bit less than full length sizing does. I love 'em and would rather buy them in deluxe sets with the other dies than have to buy them by themselves later. (they cost more that way) For all the folks that burn energy campaigning against "cheap" Lee products, I can't imagine many folks who have bought and used Collet neck-only size dies and didn't end up loving them. __________________ *Attention Brass rats and other reloaders:* I really need .327 Federal Magnum brass, no lot size too small. Tell me what caliber you need and I'll see what I have to swap. PM me and we'll discuss.