View Single Post
Old June 16, 2010, 03:21 PM   #3
James K
Join Date: March 17, 1999
Posts: 24,160
The concern I had was that the sideplate appeared to hold the curved hammer block back away from the frame. The hammer block should be flat against the frame and completely out of the way of the hammer, both vertically and horizontally, at all times.

The new one is really the same as the old, it just is made differently. I question if the middle one is even S&W; it has a sort of "home made" or after market look about it.

Jim K
James K is offline  
Page generated in 0.03586 seconds with 7 queries