View Single Post
Old January 22, 2010, 12:34 AM   #4
Senior Member
Join Date: March 18, 2009
Location: Central Colorado
Posts: 833
I think drilling the receiver on my mosin was no big deal. Sure, you have to have a drill press, but that scope mount practically snapped in place on the receiver, it didn't have the room to shift around and get out of alignment.

and I agree about the metal bending. If the rifle can unscrew the mount screws (which it won't anymore, thanks to a little Loctite) it'll deform that metal after a couple hundred rounds. I think i'm just old fashioned...
Those who hammer their swords into plow shares will plow for those who didn't...
MagnumWill is offline  
Page generated in 0.03330 seconds with 7 queries