The Firing Line Forums - View Single Post - Neck Sizing Bottle Neck Pistol Cartridges?

SL1 · September 17, 2009, 01:21 PM

Peetzakilla,

All of my reloaded .357 Sigs have been fired right now. I will process a case and answer your dimension question later.

I DID put a decapping rod in a Lee FCD. I had to buy a hex head bolt that fit the Lee die body and drill/tap it for an RCBS decapping rod. It took a drill press with machinist vice and a couple of tries to get the hole drilled straight enough to make the decapping pin line-up properly with the case flash hole. So, it is not a job you can do with a hand drill and bench vice.

SL1

September 17, 2009, 01:21 PM	#11
SL1 Senior Member Join Date: November 8, 2007 Posts: 2,001	Peetzakilla, All of my reloaded .357 Sigs have been fired right now. I will process a case and answer your dimension question later. I DID put a decapping rod in a Lee FCD. I had to buy a hex head bolt that fit the Lee die body and drill/tap it for an RCBS decapping rod. It took a drill press with machinist vice and a couple of tries to get the hole drilled straight enough to make the decapping pin line-up properly with the case flash hole. So, it is not a job you can do with a hand drill and bench vice. SL1