The Firing Line Forums - View Single Post - Reloading .223

kargo27 · September 5, 2009, 05:57 PM

Another big thanks!

I've bookmarked posted sites and put them in my "Reloading Info" folder.

Since I have a lot of LC and PMC brass, I also ordered the Dillon Super Swage 600 as well as the cartridge gauge. I think I should be good to go. Just waiting on those primers.

I forgot to ask yall about this. I got a Lee 3-piece Delux die setup. It has the case resizing die, a collet neck resizing die and then the bullet seating die. Do I use all three? I read about the collet neck sizing die and if I understand correctly it's used to clamp the cannelure tighter or less for accuracy?

September 5, 2009, 05:57 PM	#16
kargo27 Junior Member Join Date: September 2, 2009 Location: Ft. Worth, TX Posts: 9	Another big thanks! I've bookmarked posted sites and put them in my "Reloading Info" folder. Since I have a lot of LC and PMC brass, I also ordered the Dillon Super Swage 600 as well as the cartridge gauge. I think I should be good to go. Just waiting on those primers. I forgot to ask yall about this. I got a Lee 3-piece Delux die setup. It has the case resizing die, a collet neck resizing die and then the bullet seating die. Do I use all three? I read about the collet neck sizing die and if I understand correctly it's used to clamp the cannelure tighter or less for accuracy?